Jun
30
The mesh is finished!
ByFinally, after a few delays, and a much busier than anticipated summer, I’ve got the case cover finished. It just needs a little finish sanding, and it’s ready for primer and paint.
Here I’ve got the mesh marked out and ready for cutting. I always mark my cut lines with masking tape. It makes it much easier to see during cutting. It also makes it pretty easy to file straight after the cutting is done. I just file right up to the edge of the tape, pull it off, and then sand the edges.
After a little JB Weld, the mesh is in place.
Let’s get it on the case!
With the case cover done, I’m moving on to the PSU extension…
